Leaching Requirements of Pecan and Fruit Trees
Guide H-644Ted Sammis, Water Specialist Esteban Herrera, Horticulture Specialist
College of Agriculture, Consumer and Environmental Sciences New Mexico State University. (Print Friendly PDF)This publication is scheduled to be updated and reissued 2/05.
Irrigation water contains dissolved salts that can accumulate in the root zone as evapotranspiration (Et) removes irrigation water and leaves the salts behind. As excess quantities of soluble salt accumulate in the root zone, trees have difficulty in extracting water from the salty soil water solution, and transpiration and the resulting growth are reduced.
Excessive salinity build-up can be controlled by applying an additional amount of irrigation water often referred to as the "leaching requirement."
THE LEACHING REQUIREMENT
The leaching requirement (LR) is the extra water needed for leaching expressed as a fraction or percentage (leaching percentage) of the total water penetrating the soil (DD). It has been defined by the U.S. Salinity Laboratory as the fraction of the irrigation water (DI) that must penetrate below the root zone to maintain salinity at a specified level.
DD LR = ____ DI
LR varies with the salinity tolerance of the crop and the salinity of the irrigation water. For general use, it is based on quantitative salinity measurements, although leaching requirements for specific salts may also be computed. The sodium content of some irrigation waters may impose serious limitations on its use on certain soils and must be considered in an overall leaching program.
Slow soil permeability, shallow water tables, or restricted subsurface drainages may interfere with adequate leaching. Where these conditions exist, drainage must be improved before soil salinity can be reduced by leaching. In fact, poor drainage often causes excessive accumulations of salt in soil even when relatively good-quality water is used.
THE LR EQUATION
LR can also be calculated by dividing the electrical conductivity of the irrigation water (ECiw) by the electrical conductivity of water draining from the bottom of the root zone (FCdw). In practice, the ECdw value is not readily available, and the U.S. Salinity Laboratory recommends using the average electrical conductivity of the soil solution extract (ECe) and the ECiw to determine LR.
ECiw LR = ________________ 5(ECe) - EC iw
Fig. 1 shows the relationship between the salinity of the applied water and the salinity of the soil water saturation extract for different LRs.
Growth reduction does not occur in a tree until a threshold level of salinity is reached, and then growth decreases in a linear amount with increasing salinity. Relative growth rate (RGR) reduction for selected soil salinity levels in trees is presented in table 1.
Table 1. Salinity (measured as electrical conductivity) tolerance of trees as a function of (EC x 10 (3rd power)) in soil saturation extract._________________________________________________________________________________________
Representative Conductivity of medium (ÁS/m)(to the (a) power) _________________________________________________________ species 0% RGR 10% RGR 25% RGR 50% RGR _________________________________________________________________________________________ Apricot 1.6 2.0 2.6 3.7 Peach 1.7 2.2 2.9 4.1 Almond 1.5 2.0 2.8 4.1 Plum 1.5 2.1 2.9 4.3 Pecans 2.0 3.0 4.5 7.0 Grapes 1.5 2.6 4.1 6.7__________________________________________________________________________________________
(a) power = Electrical conductivity of a saturation extract (ECe) of the growing medium, measured in microSiemens per centimeter (= micronhos per centimeter).
Source: modified from Ayers (1977) and Handreck and Black (1984).
APPLYING THE LR CONCEPT
To compute the LR, the salinity of the irrigation water and the salinity tolerance of the crop must be known. These values are furnished by the NMSU Cooperative Extension Service Soil and Water Testing Laboratory as EC x 10 (6th power). These values should be divided by 1,000 to be equivalent units, with values for ECe normally given as EC x 10 (3rd power) (table 1).
Example: To grow pecans irrigated with well water with an electrical conductivity of 1,700 x 10 (-6th power) mhos:
EC x 10 (6th power) of irrigation water = 1,700. To convert to 1,700 ECiw x 10 (3rd power) = ________ 1,000 = 1.7 irrigation water EC x 10 (3rd power) = 2.0 soil (from table 1).
From fig. 1, the leaching fraction should be 0.2. Therefore, in addition to the water supplied for consumptive use (Et) (the amount of water absorbed by the plants and lost by evaporation), an additional amount equal to 0.2 Et should be applied for leaching.
Assuming uniform water application, if the irrigation efficiency (the water stored in the root zone divided by the applied water) is greater than (1 - LR), then the LR should be used to calculate depth of irrigation water. If the application efficiency is less than (1 - LR), then the LR is already being satisfied.
Assuming an irrigation efficiency greater than (1 - LR), the depth of irrigation water (Diw) to maintain a steady-state salt balance is
Et - Dr Diw = _________, 1 - LR
where Dr is runoff of applied irrigation water. It is assumed that all of the LR will be satisfied by irrigation water exclusive of any leaching by rainfall. If the value of Dr is assumed to be 0 and the intended Et for this irrigation is 3.0", then the depth of irrigation water is
3.75" = (3.0 - 0) / (1 - 0.2)
This amount of water must be applied to the portion of the field receiving the smallest water application amount so that the LR over the rest of the field is 0.2 or more.
New Mexico State University is an equal opportunity/affirmative action employer and educator. NMSU and the U.S. Department of Agriculture cooperating.Reprinted February 2000
Electronic Distribution August 2000